Must every set end only when another repetition is impossible? The evidence does not support making failure a rule for every set. But stopping a set while you could easily do many more repetitions may also miss the intended training stimulus. A useful decision considers the exercise, the load, your experience, the quality of the following sets, and what you need to recover for the next session.

Repetitions in reserve, or RIR, estimates how many more repetitions you could complete with the same technique when you stop. If you perform ten reps and think you could have completed two more, you report about 2 RIR. This is a judgment, not a measurement. Its best use is to make training decisions more consistent and to compare similar sessions over time, not to claim that you have found a perfectly precise number.

Define what “failure” means first

Failure is used in several ways in the gym. You might stop at your planned rep target, at the last rep you can perform with your chosen range of motion, or only after an attempted rep does not move. Those are different endpoints. Research papers have also defined failure differently, which complicates comparisons. In this guide, repetition failure means that you cannot complete one more repetition with the same intended range of motion and technique. You can stop earlier if you develop pain, lose balance, or must change your posture substantially to move the load.

An estimate of 0 RIR means you are at or very close to that endpoint; 1 RIR means roughly one more rep; 3 RIR means roughly three. It does not mean you must get trapped under a bar to prove that you reached zero. In a squat or bench press, the presence of safeties and a capable spotter matters. Safety is part of programming, not a footnote to it.

What does the research actually show?

Reviews comparing sets taken to failure with sets stopped before failure have not established a large, consistent hypertrophy advantage for failure. A meta-analysis by Grgic and colleagues found no clear overall difference in strength or hypertrophy between the conditions; the studies it included involved young adults. Refalo and colleagues found that when they specifically compared momentary muscular failure with non-failure, an advantage for failure was not established. Neither result means that stopping with any amount of effort left produces the same outcome. Training loads, volume, and even the definition of failure varied among the studies.

An exploratory meta-regression by Robinson and colleagues estimated RIR across several studies and found a trend toward greater hypertrophy when sets ended closer to failure. The researchers had to estimate RIR from how the training interventions were described; it was not directly measured in all participants. Model fit was limited. This is not evidence for a universal prescription such as “exactly 2 RIR for everyone.” The practical interpretation is to perform sufficiently challenging sets while checking whether extra effort compromises later sets and recovery.

The target outcome also matters. The same analysis did not find the relationship between estimated RIR and strength gains to be as clear as its relationship with hypertrophy. Maximum strength involves practice with heavy loads and the movement itself. A plan focused on strength therefore needs its own decisions about loads, technique, and fatigue instead of copying a hypertrophy rule.

RIR is an estimate, especially at lighter loads

People can misjudge how many reps remain, particularly when the load is lighter and a set has many repetitions. Hughes and colleagues studied 21 resistance-trained men performing common exercises. Participants announced when they believed they had two reps left, then continued to failure. Their estimates were more accurate at 85% of one-repetition maximum than at 65% or 75%, where they were more likely to underestimate the repetitions remaining. The study is small and does not show that everyone makes the same error. It does show why an asserted “2 RIR” in a light, long set deserves some caution.

If you are new to lifting, begin with broad categories: comfortable, only a few reps left, and uncertain whether another clean rep is possible. Learn to keep your range of motion and technique consistent before trying to distinguish 2 RIR from 3 RIR. Even experienced lifters should not compare a shortened rep or a set with major body English to an earlier set as though the endpoint were identical.

Put it to work in today’s session

Suppose you plan three sets of dumbbell bench press in an 8–12 rep range. On the first set, keep the movement controlled and stop when you believe you could do another two or three clean reps. Use a consistent rest period and repeat. If repetitions drop sharply on the next set, review the rest interval, load, exercise order, and technique before deciding that you simply need to push harder. On the final set, moving somewhat closer to failure may be reasonable if you can manage the dumbbells safely and still recover for your plan. This is an editorial example, not a uniquely proven protocol.

SetExample logWhat to check next
120 kg × 11 reps, about 3 RIRWas the path and depth repeatable?
220 kg × 10 reps, about 2 RIRDid technique hold after the rest?
320 kg × 9 reps, about 1 RIRCan you reproduce the conditions next time?
RIR is an estimate of reps left
RIR 0 · Another rep seems unlikelyDo not count a breakdown in technique as success
RIR 1–2 · Perhaps one or two moreAn estimate, not a measurement
RIR 3+ · More room remainsThe number alone does not define stimulus
How to read the scale, not a universal target RIR.

These are illustrative numbers, not observed results. Record the weight, reps, sets, an approximate RIR, and a short note if the range of motion or posture changed. If you gain reps at the same load while keeping the movement comparable, you have useful evidence of progress even if your RIR estimate was off by one. If you report 0 RIR on every set and repetitions collapse, consider your rest and total work before adding more all-out sets.

Let the exercise and your skill influence the stopping point

With a heavy compound lift, a little more margin can help you preserve technique and manage an unsuccessful rep. On a properly set-up machine or some isolation exercises, approaching failure may be easier to control. Neither setting makes it necessary to train through pain or to prioritize a target RIR over a worrying joint sensation. When learning a new exercise, repeatable technique matters more than a precise effort score.

A beginner’s “2 RIR” may also be less reliable than the same rating from someone familiar with the movement. In the first weeks, use manageable loads, learn the movement, and notice how repetitions change across sets. A more experienced lifter can compare the same exercise at a similar place in the session, with similar rest and range of motion, then adjust effort after several weeks of data. Before responding to a plateau with more failure training, examine weekly set volume, sleep, food, and the rest of your schedule.

Log the decision and change one thing next week

RIR is not a score for how hard you worked. For example, compare the first working set of the same press each week: load, reps, estimated RIR, and rest. After roughly four weeks, ask whether repetitions increased at a similar effort or the load rose while technique stayed comparable. If progress has stalled, alter one relevant condition and compare again. Our guides to hypertrophy fundamentals, rest between sets, choosing a training load, and reviewing your training log provide the wider context.

TRAINING PRESS is published by GOODBOY STUDIOS, the company behind GROWTH. GROWTH can record weights, reps, and sets and help you compare a session with the previous one. We are not claiming a dedicated RIR field here. If the app offers a suitable note field, use it to capture an effort estimate and any change in technique according to the actual version you use. The point of a log is to make the next choice better, not to collect numbers for their own sake.

Common questions

Will 0 RIR on every set build muscle faster?

You cannot assume that. Reviews have not shown a consistent need to reach failure on every set, and the added fatigue may reduce later performance. Consider the entire session and week.

Does 2 RIR create the same stimulus in every exercise?

No. Load, exercise, and familiarity affect both the sensation and the accuracy of the estimate. Compare repeatable movement conditions and longer-term performance rather than treating one number as interchangeable across exercises.

Can I push only the last set closer to failure?

That is one option on an exercise where you can safely manage an unsuccessful repetition, provided technique and recovery remain acceptable. It is not a universal requirement. Stop if you feel pain or unwell, and seek medical advice when appropriate.

Takeaway

RIR is a practical estimate of set effort, not a calibrated instrument. You do not need failure on every set. Make the work challenging enough to serve your goal, then consider the quality of later sets and your recovery. Track weight, repetitions, and movement conditions consistently, and adjust your stopping point from trends over several weeks.

References

  • Grgic J, et al. Effects of resistance training performed to repetition failure or non-failure on muscular strength and hypertrophy: a systematic review and meta-analysis. Journal of Sport and Health Science. 2022;11:202–211. doi:10.1016/j.jshs.2021.01.007. https://pubmed.ncbi.nlm.nih.gov/33497853/
  • Refalo MC, et al. Influence of Resistance Training Proximity-to-Failure on Skeletal Muscle Hypertrophy: A Systematic Review with Meta-analysis. Sports Medicine. 2023;53:649–665. doi:10.1007/s40279-022-01784-y. https://pubmed.ncbi.nlm.nih.gov/36334240/
  • Robinson ZP, et al. Exploring the Dose-Response Relationship Between Estimated Resistance Training Proximity to Failure, Strength Gain, and Muscle Hypertrophy: A Series of Meta-Regressions. Sports Medicine. 2024;54:2209–2231. doi:10.1007/s40279-024-02069-2. https://pubmed.ncbi.nlm.nih.gov/38970765/
  • Hughes LJ, et al. Estimating Repetitions in Reserve in Four Commonly Used Resistance Exercises. Journal of Strength and Conditioning Research. doi:10.1519/JSC.0000000000003865. https://pubmed.ncbi.nlm.nih.gov/33337690/